Belkin router red light is a common problem for users. Is your Belkin router not working? There must be a problem when the light of your Belkin router blinks red. But what exactly is the reason behind it?
Perhaps it has something to do with the connection between it and the main modem. For all we know, you might have hooked it with an unsupported mode.
The light code problem could also occur due to slow Internet or critical firmware update. Or the Internet cable and connection loss may be responsible for it too.
Learning the basic steps to troubleshoot Belkin router red light is vital. If you ever find yourself facing it, you can figure out what to do to get your Internet back once more.
So, let’s dive right into it!
How to Fix the Belkin Router Red Light
Check the Cable Connections
The LAN cable is the bloodline of your Internet. If you’re having a connection issue on your devices, then this might be the one behind it.
To test if this bridge that sends the Internet running in your device still functions as usual, plug it into an Ethernet cable tester and wait for it to successfully transmit a signal. If not, then it has already malfunctioned. You can try connecting the modem and router a different cable to have the issue resolved.
Even after all those attempts and the Belkin light still red? Continue to the next step.
Can you like: How to Setting Up Belkin Router by Using Web
Perform a Power Cycle
Belkin routers, like any other routers, have their break periods once in a while. It’s not always clear why. If this is the case, you should run a power cycle. This means switching the power OFF and then ON again, and this seemingly over-simplistic trick can fix tons of basic problems.
Please note, you’re restarting devices that work together – modem and Belkin wireless router. It would be best if you cycled them at the same time.
With enough luck, you can restore the Internet connection after this. Or else, you have to come to the third method.
Read more: Belkin Router Setup Page – How to Use It to Configure an Access Point?
Update the Belkin Router Firmware
A firmware update includes improvements to the performance of your Belkin router. It might also resolve problems that the previous microcode version may have.
Not until you check your Belkin router’s model and version number should you download the firmware. After going through the update via Belkin’s web interface, check the connections. If the red light persists, there is no other choice but to reset the router!
Reset Belkin Router
Resetting your Belkin router is a helpful walkaround, especially when the device does not work as expected.
REMEMBER: Keep in mind to restart the PC as well. Otherwise, the problem will persist.
First, look for the reset button of your router. Its location may vary depending on the model of your router. When the router is powered ON, press and hold the button for 15 seconds.
Next, wait for 1 minute for the router to restart. Your Belkin router has now been reset to its factory default settings. The red light will disappear and be replaced by a solid blue flash. You then have to set up your router data again.
That is the final tip to deal with the red light appearing on the Belkin router. If the flash is still red, you’d better consult Belkin wireless router experts.
See also: How to Reset Belkin Router to Factory Default Settings?
Wrapping Up
Fixing Belkin router red light is not that complicated. By getting around the problem yourself instead of phoning the network service right away, you will be able to have your Internet back faster, and all the quite save quite a sum of money.
